|
|
 |
Step
1: Cut the
PEX-AL-PEX pipe vertically and precisely with a pipe
cutter (Picture 1.1, Ardi GJ III cutter). |
|
|
|
  |
Step
2: Round and bevel the end holes with the Ardi
reamer(14-32 ZYD Plastic reamer or 14-32 JD T-reamer).
(Picture 1.2 and 1.3) |
|
|
|
 |
Step
3: Choose the right size sleeved-fitting for the
PEX-AL-PEX pipe, then aim the pipe end at the
ring-shape hole of the fitting integrated with sleeve
and slide the PEX-AL-PEX fitting insert into the pipe
until it reaches the plastic block. Check the inserting
depth by looking through the inspection holes on the
sleeve shoulder to ensure that the
PEX-AL-PEX pipe is completely inserted. (Picture
1.4) |
|
|
|
 |
Step
4: It is recommended to use REMS TH profile electric
pressing tool for F9II PEX-AL-PEX fitting installation.
(Picture 1.5) |
|
|
|
|
Step 5:
Pressing the button on the latch bar and the pin will be
released automatically. (Picture 1.6 and 1.7) |
  |
|
|
|
 |
Step
6: Positioning the corresponding jaw into the groove
in the tool. (Picture 1.8). |
|
|
|
 |
Step
7: Pressing the latch bar back on position and the
bar will be locked on the tool automatically (Picture
1.9). |
|
|
|
 |
Step
8: Pressing the tail to open the jaw (Picture 1.10). |
|
|
|
 |
Step
9: Ensure the plastic block and sleeve are at the
right position in the jaw; the margin of the block must
be placed into the groove of the pressing section. Note:
the plastic ring is placed into the tong head, there is
a groove in the tong head for the ring section when you
press. (Picture 1.11) |
|
|
|
 |
Step
10: Operating the tool by trigger and holding the
trigger until the pressing process is finished, a
warning signal will sound when the pressing is done.
(Picture 1.12) |
|
|
|
|
|
