Screw PEX-AL-PEX Fittings (F1) Installation Instruction

Step 1: Cutting the PEX-AL-PEX pipe

Cut the pipe at right-angles using a pipe cutter.

Step 2: Rounding

Round and bevel the end holes of the multilayer pipe and make a no-less-than-2-minimeter incline.

Step 3: Installation of screw PEX-AL-PEX fitting

Choose the right size fitting according to the PEX-AL-PEX pipe, put the nut over the pipe, slide the compression ring over the pipe, make sure the mouth of the nut and the pipe faces the same direction.

Step 4: Installation of inserts

Push the inserts into the multilayer pipe up to the shoulder; take care not to damage the O-ring.

Step 5: Tightening

Use a spanner to tighten it up completely.